Software Downloads and Manuals

The Supported Slicing Softwares for our Select Mini V2 3D Printer are Cura and Repetier-Host. 

These programs are pre-installed on the memory card that comes with the printer.  

You can find the links for Cura Versions & Firmware Downloads on the product page here: 

https://www.monoprice.eu/collections/3d-printers/products/monoprice-select-mini-v2-3d-printer-with-heated-build-plate

Here a few of the most important downloads:

• Updated firmware version 30 for the V1 version of the printer with firmware version less than v30 (Feb 9, 2018)
• Updated firmware version 40 for the V2 version of the printer with firmware version greater than v34 (Feb 9, 2018)
• Updated firmware version 41 for the V2 version of the printer with firmware version v40. If not already at V40, upgrade to v40 first. (Mar 1, 2018)
• Updated profiles for the latest version of Cura (Oct 26, 2017)